In networking terminology, a bridge serves a similar function in that it spans two local area networks and allows packets to get from one to the other.īridges and routers are both network connectivity devices that connect network segments together. In the “real world,” a bridge is a structure that spans the distance between two locations and provides a link or connection from one place to another.
Ethernet adapter mac address windows xp how to#
After walking you through the process of configuring bridged connections, I’ll explain how to troubleshoot problems with the network bridge. I’ll also discuss how the network bridge works under the hood. In this Daily Drill Down, I’ll look at the difference between bridging and routing and discuss how you can use a bridge as a low-cost alternative to routing. Step 6.Click OK to save and apply your settings.Get IT Done: Connect LANs with Windows XP’s Network BridgeĬonnect two LAN segments via Windows XPs Network BridgeĪ new feature in Windows XP is the Network Bridge, which allows you to connect two LAN segments-even if they use different media types-without buying expensive hardware or third-party software. For the Secondary DNS server, you could leave it blank or type in 8.8.8.8. The Preferred DNS server is the same as to default gateway. Step 5.There are two ways to configure the TCP/IP Properties, Assigned by DHCP server a utomatically or manually.ġ) Select Use the following IP address, type IP address, subnet mask and default gateway IP address into it. Double-click on Internet Protocol Version 4 or click Properties. Highlight and right-click on Ethernet, then select Properties. Click on Network and Internet -> Network and Sharing Center, click on Change adapter settings on the left side. Press Windows key + X at the same time and select Control Panel. Step 5 Click OK to save and apply your settings. The Preferred DNS server is the same as the default gateway. Note: In most cases, type your local area DNS server IP addresses into it. If necessary, then click OK to save the settings. And then type the DNS server IP address, which should be provided by your ISP. If necessary, then click OK to save the settings.ġ) Select Use the following IP address, type the IP address, subnet mask, and default gateway IP address into it.Ģ) Select Use the following DNS server addresses, as shown in the following figure.
Select Obtain an IP address automatically and Obtain DNS server address automatically. There are two ways to configure the TCP/IP Properties, Assigned by DHCP server a utomatically or manually. Step 3.Select Internet Protocol Version 4(TCP/IPv4), double click it or click Properties.
Highlight and right-click the Local Area Connection icon and select Properties. In the task list, please click Manage network connections (for Windows Vista )/Change adapter settings (for Windows7 ). Click Start -> Control Panel -> Network and Internet -> Network and Sharing Center. Click OK to save and apply your settings. Finally, remember to click OK to save settings. If the router’s LAN IP address is 192.168.1.1, please type in IP address 192.168.1.x （x is from 2 to 253）, subnet mask 255.255.255.0, and default gateway 192.168.1.1.Ģ) Select Use the following DNS server addresses, as shown in the following figure. Then click OK to save setting.ġ) Select Use the following IP address, as shown in the following figure. Select Obtain an IP address automatically and Obtain DNS Server address automatically, as shown in the figure below. Step 4.Now you have two ways to configure the TCP/IP protocol below: The TCP/IP Properties window will display. Highlight the Internet Protocol (TCP/IP) tab, and then double click it or click Properties. Click the Properties button to open up the properties window. Step 2.Highlight and right-click the Local Area Connection icon c lick on Status and go to General. Step 1.Click Start->Control Panel->select and double click Network and internet connections (If you can´t find it, please go next) ->select and double click Network Connections.
0 kommentar(er)
